VIGI PS90
NewVIGI Solar System Controller
- 93.6Ah/10.95V Automotive-Grade Lithium Battery (31.2Ah Per Lithium Battery)
- Remote Management and Maintenance via the VIG app or VIGI Cloud VMS
- Indendent Protection Circuit Ensures Battery Safety and Uninterrupted Device Operation
- Intelligent Auxiliary Heating Technology Ensures Optimal Battery Performance in Extreme Cold Weather
- Maximum Power Point Tracking (MPPT) Charging Controller Increases Charging Efficiency by 20%*
- Remaining Capacity > 70%** after 500 Cycles
- IP66 Weatherproof
-
Customized Ternary
Lithium Up to 93.6Ah -
Independent
Protection Circuit -
MPPT
Controller -
Remote
Management -
IP66 Weatherproof
-
Automotive-Grade Lithium Battery
-
>500 Cycles
-
Discharge Efficiency
Up to 99%
Remote Management
Equipped with a built-in MPPT Controller, VIGI PS90 integrates seamlessly with network devices, allowing centralized control via the VIGI app or VIGI Cloud VMS. Remotely monitor power statistics, receive low-battery alerts, update firmware, and reboot the system—all without needing on-site presence. Enjoy peace of mind, wherever you are.
-
VIGI App
-
VIGI Cloud VMS
Independent Protection Circuit
Each individual battery has its own protection circuit, which prevents failures in one battery from affecting the entire battery pack. This design ensures battery safety and uninterrupted device operation.
-
Independent Protection Circuit
If a single battery fails,other batteries still work normally
-
No Independent Protection Circuit
If a single battery fails, other batteries are at risk of damage
MPPT Controller Boosts Charging Efficiency
An MPPT (Maximum Power Point Tracking) controller optimizes solar panel power, reduce power losses, and increase charging efficiency by 20% compared to PWM (Pulse Width Modulation) controllers.
-
MPPT Controller
-
PVM Controller
Intelligent Auxiliary Heating Technology
The built-in smart battery supports intelligent auxiliary heating technology, which allows the battery to operate normally across a wide temperature range.
-
Charge and Discharge Temperature Limit Comparison
Charging Temperature
Discharging Temperature
VIGl Smart Battery with Intelligent Auxiliary Heating
Traditional Battery without Intelligent Auxiliary Heating
-
Actual Discharge Comparison at the Same Temperature
Discharge Capability
-
VIGl Smart Battery with Intelligent Auxiliary Heating
-
Traditional Battery without Intelligent Auxiliary Heating
*The auxiliary heat will only be turned on when the photovoltaic system has a certain input or the battery has a certain amount of power. The test environment consisted of a 20°C aging box and 1A constant current discharge.
-
Strong Weatherproof Box for Outdoor Use
-
IP66 Weatherproof
-
-30℃~45℃ Charging ConditionΔ
-
10%~90%RH Working Humidity
-
-30℃~60℃ Discharging ConditionΔ
-
Frim Box Material
High-quality SGCC galvanized steel and coated with a resin powder finish for enhanced corrosion resistance.
-
Engineering-Grade Outdoor Lock
Durable and reliable, this lock resists clogging and rust. It also features a polyamide engineering plastic sheath for added protection.
-
Zinc Alloy Hinge
Allows 180° opening and closing with excellent corrosion and wear resistance.
-
Foam Rubber Waterproof Ring
Crafted from polyurethane foam for strong airtight waterproofing, along with corrosion and aging resistance.
-
Special Water Drainage Design
If water enters the box, it will flow along the edge of the lid and exit through the designated drainage holes.
-
Explosion-proof Valve
ΔWith intelligent auxiliary heating
| Battery | |
|---|---|
| Type | Lithium |
| Intelligent Auxiliary Heat | Yes |
| Battery Capacity | 93.6Ah(Max),31.2Ah(Per Lithium Battery) |
| Voltage | 10.95 V |
| Max. Output Voltage | 12.6 V |
| Life | More than 500 cycles† |
| Dimension | • 9.4×2.9×2.8 in (240×74×72 mm) (Per Lithium Battery) |
| Charging Condition | • 0°C~45°C• -30°C~45°C (With intelligent auxiliary heating) |
| Discharging Condition | • -20°C~60°C• -30°C~60°C (With intelligent auxiliary heating) |
| HARDWARE | |
|---|---|
| Interface | • 1× Three-pin Female Connector For Connecting The Controller• 1× Three-pin Male Connector For Connecting The Modular Battery• 2× Four-pin Female Connectors For Connecting The Solar Panel• 1× 10/100 Mbps RJ45• 3× 5.5mm DC Power Plugs (#1, #2: 9V-12.6 VDC/2A, #3: 12 VDC/2A) |
| Indicator LED | • Quantity: 6 (1× SYS Indicator, 1× LAN Indicator, 1× PV Indicator, 3× BAT Indicator)• Color: Blue |
| SOFTWARE FEATURES | |
|---|---|
| Load Control | Yes |
| High and Low Temperature Protection | Yes |
| Overdischarge Protection | Yes |
| Power Consumption Statistics | Yes |
| Displays Real-time Load Status | Yes |
| Battery Level Display | Yes |
| Time Zone Selection | Yes |
| Schedule Saving | Yes |
| Firmware Remote Update | Yes |
| Remote Reboot | Yes |
| Local LAN Management | Yes |
| Smart Charging Control | -30°C~5°C |
| Account Management | Yes |
| Remote Reset | Yes |
| Remote Message Push | Yes |
| OTHERS | |
|---|---|
| Certification | • CB, PSE (Battery)• CE, FCC, VCCI, IC, IP66 |
| Package Contents | • VIGI PS90• Installation Guide• Waterproof Cable Attachments• Mounting Accessories• Extension Cable• Box Key |
| Box Dimensions (W X D X H) | 18.9×16.8×6.4 in (481*426*163 mm) |
| Weight | • Product Weight: 16.5 kg• Package Weight: 24 kg |
| Environment | • Operating Temperature: -30°C-60°C (With intelligent auxiliary heating)• Operating Humidity: 10%~90%RH, Non-condensing |
*This value is compared to the PWM (Pulse Width Modulation) controller. Actual performance will vary as a result of client limitations and environmental factors.
**Calculations based on laboratory testing. Actual performance will vary as a result of client limitations and environmental factors.
†A cycle represents one full charge and discharge. Based on 30Ah capacity with VIGI C540-4G, 500 cycles approximate a 10-year lifespan.