How to configure IPv6 settings on TD-8816 V8, TD-8817 V8, TD-W8151N V4, TD-W8901N V2, TD-W8951ND V6

Note: Here we take TD-W8951ND as an example to set up IPv6 Settings. Please make sure your ISP does provide you IPv6 access service. If so, please refer the following steps to configure IPv6 settings on this modem router.

Before we do the configuration on this modem router, please see the following topology and make sure the physical connection is correct, and then check the ADSL light (), assure ADSL light is solid on, not flashing or off. If physical connection is no problem, plug your laptop or PC to the LAN port (any LAN port is OK) of this modem router by Ethernet cable.

Step 1: Log in to the Web-based Management Interface of TD-W8951ND by http://192.168.1.1(Default username & password: admin, admin.)

Step 2: Go to Interface Setup > Internet, choose "IPv4/IPv6", and choose the "Encapsulation/Connection type" (Here we take PPPoA/PPPoE as an example, if you are not sure, please contact your IPv6 provider.), type in the PPP username & PPP password from ISP.

Step 3: Go to Interface Setup > Internet, Choose "DHCP IPv6 Enable" as "DHCP" or "SLAAC", it depends on your ISP. If you are not quite sure which one is yours, please contact your ISP to confirm it.

Step 4: Go to Interface Setup > LAN, Enable "Radvd", Enable "DHCPv6 Server", and then click on "Save" button.

Step 5: Go to Statas > Device Info > IPv6, check the IPv6 information as follow; if it has "IP Address" in the table, and "Status" shows "UP", it should be configured successfully.